AFM Safecoat Concrete Floor Paint

high-performance, waterborne coating designed primarily for use on dimensionally stable floors and decks
by AFM
$61.90

This unique waterborne coating is ideal for interior concrete floors, dimensionally stable decks including magnesite, walkways, breezeways and patios. It provides a hard, tough coating, yet contains no offensive solvents, fumes or odors. It dries quickly, cleans up with water and provides a tough, monolithic film for lasting protection. Safecoat Concrete Floor Paint is fully tintable to hundreds of colors


SURFACE PREPARATION:

Clean surfaces of dirt, grease, mildew and oil. New cementitious surfaces should age at least thirty days and have a pH below 10 before coating. For the best adhesion on smooth surfaces with no surface profile, acid-etching may be required, followed by completely neutralizing the surface. Use extreme caution when working with acid and follow label and MSDS precautions. All acid residual must be removed prior to coating. Surface pH should be 7-10 for best results. Test surface porosity and profile by dropping water onto dry surface. If water drops fail to penetrate quickly, surface may need additional attention to create proper surface profile. Test for surface cleanliness by applying a strong tape (such as duct tape) to the cleaned areas and pull back up. The tape must be clean and free of any concrete dust or dirt. If particles or a white residue are still present, remove them completely with additional scrubbing, rinsing, and possibly etching.


APPLICATION: 

Before using, stir Safecoat Concrete Floor paint well, then apply as is stirring occasionally during use. Apply with a brush, pad or roller. Apply in two or more uniform, thin coats. Cross-roll to avoid lapmarks and holidays. 


COVERAGE:  One gallon covers approximately 350 square feet.

CAUTION: COATED SURFACES MAY BECOME SLIPPERY WHEN WET. A slip-resistant floor finish additive is available to help prevent slip if desired. Adding a slip resistant additive may reduce the life span of the product in heavy traffic areas.

CLEAN-UP: Clean tools and equipment while they are still wet with a warm soapy water solution.

DRYING/CURING TIME: Dries to touch in 4-12 hours. Allow 24 hours between coats. Normal conditions include a dry surface, access to fresh air flow, moderate humidity,

LIMITATIONS: Safecoat paints are made without formaldehyde preservatives. Do not contaminate. Store in airtight containers. Do not use when indoor temperature is below 55 degrees F. Do not freeze. Thick application, high humidity or conditions other than normal will cause Safecoat to dry and cure more slowly.

HEALTH PRECAUTIONS: As with all coatings and sealers, keep container tightly closed and out of the reach of children. Do not take internally. Keep from freezing. Always use adequate ventilation.

AFM Safecoat Concrete Floor Paint SDS

LIMITED LIABILITY: Safecoat products are guaranteed by the manufacturer not to be defective when properly applied. Liability express or implied is limited to replacement of product or refund of purchase price and does not include liability for labor costs or consequential damages. Variable factors out of manufacturers control, such as environmental conditions, application techniques, and surface conditions are critical to results obtained. Users are expected to exercise reasonable care to determine suitability of the product for each application. We particularly recommend that users always test in small inconspicuous areas before application to the entire surface.


Country of Manufacture: US